User Manual

Master Fader and My Fader Reference Guide
78
Chapter 9 : Channel View : Input Routing View
Introduction
The input routing view is the place to adjust all assignments and sends for each channel in a convenient
location.
The input routing view is divided into three sections:
• Source Selection
• Assignments (for the current channel)
• Aux and FX Send Assignments (for the current channel)
Let’s check all three out, shall we? With nothing assigned, the default view will look something
like the image shown below.
The input routing view on a DL1608 and DL806 look similar except for the following:
(1) Trim and polarity only; no source selection, gain or 48v.
(2) Four subgroups, VCAs, mute and view groups (versus six of each on the DL32R).
(3) Four auxes [DL806] and six auxes [DL1608] (versus 14 on the DL32R).
(4) One reverb slider (versus two on the DL32R).