Owner`s manual

DL32R Owner’s Manual
10
Removable Expansion Slot
This slot accepts expansion cards for audio networking, recording and other control options.
Each card contains pull tabs for easy installation and removal of cards, as well as two Phillips head
screws to hand-tighten the card to the mixer. The DL32R comes with a standard network card already
installed. As seen in the illustration below, this card contains a single network port for control.
Here’s how to remove a card from the mixer’s expansion slot:
(1) — Using a Phillips screwdriver, unscrew and remove the two screws keeping the card secured
to the mixer. Keep the screws in a safe place; you’re going to re-use them!
(2) — Using your index nger and thumb of each hand, grab the card’s two pull tabs and gently
remove the card straight out from the mixer.
(3) — Place the card in an antistatic bag – one is included with the new card – and keep it in a safe
place; you might re-use it some day.
Adding a card to the mixer is basically the same steps as above, but in reverse:
(1) — Remove the card from the antistatic bag and admire its beauty.
(2) — Using your index nger and thumb of each hand, grab the card’s two pull tabs and gently
slide the card straight into the mixer.
Make sure to line up the card with the side rails before sliding the card in.
There are notches located at the bottom on each side of the expansion slot
to help line up and easily guide the card.
(3) — Using a Phillips screwdriver, hand-tighten the two screws (that you kept in a safe place!),
to keep the card secured to the mixer.
Screw
Screw
Pull tabs