User Manual

DL32R Owner’s Manual

To connect unbalanced lines to these inputs, use a 1/4" mono (TS) phone plug, wired as follows:

1/4" TS Unbalanced Mono Wiring:

Sleeve = Shield

Tip = Hot (+)

Unbalanced cables can be noisy. If the studio monitors support balanced cables,

we highly recommend using those instead of unbalanced cables.

Phones Output Jack

This 1/4" TRS connector supplies the output to stereo headphones. The volume is controlled with the

phones knob located to the left of the output jack. The signals sent to this jack are the same as the signals

sent to the monitor outputs, described on the previous page.

The phones output follows standard conventions:

Tip = Left channel

Ring = Right channel

Sleeve = Ground

Phones Knob

This knob is used to adjust the volume from the phones output jack, from o to maximum gain (max).

The phones knob is an analog control, and is therefore NOT recallable.

Warning: The headphone amp is loud and could cause permanent hearing damage.

Even intermediate levels may be painfully loud with some headphones. BE CAREFUL!

Always turn the phones knob all the way down before connecting headphones, soloing

a channel or doing anything new that may aect the headphone volume. Then turn it up slowly as

you listen carefully.

Power LED

For the most part, this dual-colored LED will illuminate solid green when the DL32R is powered on

and funtioning normally. However, this LED could also illuminate red, and it has several other identiers,

as well. Please refer to the table in Appendix C for all possibilities.

Network LED

For the most part, this dual-colored LED will illuminate solid green when the basic card is functioning

normally and an iPad connection is established

. However, this LED could also illuminate red, and it

has several other identiers, as well. Please refer to the table in Appendix C for all possibilities.

SLEEVE

TIP

TIPSLEEVE

TIP

SLEEVE

TIPSLEEVE

TIP

RING

TIP

SLEEVERING