Owner`s manual
Table Of Contents
- Front Cover
- Important Safety Instructions
- Read This Page!
- Introduction
- CONTENTS
- Hookup Diagrams
- Rear Panel Features
- Front Panel Features
- 7. MIC INPUTS
- 8. MONO LINE INPUTS (CH. 1 to 4)
- 9. LINE/INSTRUMENT INPUTS (CH. 5 and 6)
- 10. STEREO LINE INPUTS (CH. 7 and 8)
- 11. RCA INPUTS (CH. 7 and 8)
- 12. INSERT (CH. 1 to 6)
- 13. TAPE OUTPUTS
- 14. BREAK SWITCH and LED
- 15. FX/MON 2 SEND OUTPUT
- 16. FX FOOTSWITCH
- 17. MON 1 SEND
- 18. MAIN SUB
- 19. MAIN OUTPUTS
- 20. POWER AMP INPUTS
- 21. MON 1
- 22. FX/MON 2
- 23. HIGH EQ
- 24. MID EQ
- 25. LOW EQ
- 26. OVERLOAD (OL) LED
- 27. CHANNEL LEVEL
- 28. GAIN SWITCH
- 29. COMPRESSOR
- 30. HI-Z SWITCH
- 31. POWER LED
- 32. MAIN MASTER GRAPHIC EQ
- 33. FX TO MAIN
- 34. MAIN LEVEL
- 35. 100 Hz RUMBLE REDUCTION SWITCH
- 36. MAIN MIX METERS
- 37. MONITOR 1 MASTER GRAPHIC EQ
- 38. FX TO MON 1
- 39. MONITOR 1 LEVEL
- 40. 100 Hz RUMBLE REDUCTION SWITCH
- 41. MONITOR 1 METER
- 42. PHANTOM SWITCH
- 43. PRECISION PASSIVE EQ
- 44. POWER AMP LIMITER LEDs
- 45. FX/MON 2 SEND MASTER
- 46. SIG/OL LED
- 47. FX SEND (POST)/MON 2 SEND (PRE)
- 48. PRESET DISPLAY
- 49. PRESET SELECTOR, TAP DELAY and LED
- 50. INTERNAL FX MUTE
- Appendix A: Service Information
- Appendix B: Connections
- Appendix C: Technical Information
- Appendix D: Table of Effects Presets
- PPM608 Limited Warranty
- REAR COVER
6
PPM608
PPM608
Hookup Diagrams
Club System
SWA1801z Powered Subwoofers
(plays main mix below 100 Hz)
Microphones
press HI-Z
button
Keyboards
SRM450v2 Powered Stage Monitors
(plays mon 1 output)
Portable Recorder
Rear Panel
Front Panel
Power Amp Mode
switch set to
Stereo Main
Adjust
Voca l
Compression
press HI-Z
button
S215 Passive Speakers
(plays stereo main mix)
This diagram shows microphones attached to channels 1 and 2, electric guitars connected directly to
channels 5 and 6 (with hi-z switch pressed in), and a keyboard attached to channel 7's stereo inputs. A
portable recorder is attached to the stereo tape outputs to record the performance.
Mackie SRM450v2 powered speakers are connected to the monitor 1 send, and are set up as stage
monitors. The mon 1 controls of each channel allow you to create a stage monitor mix that is indepen-
dent of the main mix. Use the monitor 1 graphic EQ to adjust the stage monitor EQ as desired.
Mackie S215 passive speakers are connected to the speaker-level power output of the powered mixer,
and they play the main stereo mix to your audience. SWA1801z powered subwoofers are connected to
the main mix sub out, to reinforce the low end in your system.