Owner`s manual
Table Of Contents
- Front Cover
- Important Safety Instructions
- Read This Page!
- Introduction
- CONTENTS
- Hookup Diagrams
- Rear Panel Features
- Front Panel Features
- 7. MIC INPUTS
- 8. MONO LINE INPUTS (CH. 1 to 4)
- 9. LINE/INSTRUMENT INPUTS (CH. 5 and 6)
- 10. STEREO LINE INPUTS (CH. 7 and 8)
- 11. RCA INPUTS (CH. 7 and 8)
- 12. INSERT (CH. 1 to 6)
- 13. TAPE OUTPUTS
- 14. BREAK SWITCH and LED
- 15. FX/MON 2 SEND OUTPUT
- 16. FX FOOTSWITCH
- 17. MON 1 SEND
- 18. MAIN SUB
- 19. MAIN OUTPUTS
- 20. POWER AMP INPUTS
- 21. MON 1
- 22. FX/MON 2
- 23. HIGH EQ
- 24. MID EQ
- 25. LOW EQ
- 26. OVERLOAD (OL) LED
- 27. CHANNEL LEVEL
- 28. GAIN SWITCH
- 29. COMPRESSOR
- 30. HI-Z SWITCH
- 31. POWER LED
- 32. MAIN MASTER GRAPHIC EQ
- 33. FX TO MAIN
- 34. MAIN LEVEL
- 35. 100 Hz RUMBLE REDUCTION SWITCH
- 36. MAIN MIX METERS
- 37. MONITOR 1 MASTER GRAPHIC EQ
- 38. FX TO MON 1
- 39. MONITOR 1 LEVEL
- 40. 100 Hz RUMBLE REDUCTION SWITCH
- 41. MONITOR 1 METER
- 42. PHANTOM SWITCH
- 43. PRECISION PASSIVE EQ
- 44. POWER AMP LIMITER LEDs
- 45. FX/MON 2 SEND MASTER
- 46. SIG/OL LED
- 47. FX SEND (POST)/MON 2 SEND (PRE)
- 48. PRESET DISPLAY
- 49. PRESET SELECTOR, TAP DELAY and LED
- 50. INTERNAL FX MUTE
- Appendix A: Service Information
- Appendix B: Connections
- Appendix C: Technical Information
- Appendix D: Table of Effects Presets
- PPM608 Limited Warranty
- REAR COVER
9
Owner’s Manual
Owner’s Manual
Microphones
press HI-Z
buttons
Guitar Processor
(connected to INSERT)
Send
Return
Keyboards
C300z Passive Stage Monitors
(plays mon 1 output)
SA1532z
Powered
Speaker
SA1532z
Powered
Speaker
C200 Passive Stage Monitors
(plays mon 2 output)
Rear Panel
Front Panel
Power Amp Mode
switch set to
Mon 1/Mon 2
Adjust
Voca l
Compression
Electronic Drum Kit
SWA2801z
Powered Subwoofer
(plays left main mix)
SWA2801z
Powered Subwoofer
(plays right main mix)
Large Band System
This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars con-
nected directly to ch. 5 and 6 (with hi-z switch pressed in), a guitar processor connected to ch.6 insert,
a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel 8. Add
vocal compression as required, by tweaking the compression knobs on channels 1 to 4.
The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on
channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play.
Mackie SA1532z powered speakers and SWA2801z powered subwoofers are connected to the line-
level main mix outputs, and play the stereo main mix to your audience.
C200 passive stage monitors are connected to the channel B speaker-level power output of the pow-
ered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors are
connected to the channel A speaker-level power output, and play stage monitor mix 1.