DIGITAL AUDIO HARD DISK RECORDER Operation Guide SDR24/96 Operation Guide

51
Operation Guide
Operation Guide
Pin 1 + Ch 8 Ch16 Ch24
Pin 2 shield Ch 8 Ch16 Ch24
Pin 3 – Ch 7 Ch15 Ch23
Pin 4 + Ch 6 Ch14 Ch22
Pin 5 shield Ch 6 Ch14 Ch22
Pin 6 – Ch 5 Ch13 Ch21
Pin 7 + Ch 4 Ch12 Ch20
Pin 8 shield Ch 4 Ch12 Ch20
Pin 9 – Ch 3 Ch11 Ch19
Pin 10 + Ch 2 Ch10 Ch18
Pin 11 shield Ch 2 Ch10 Ch18
Pin 12 – Ch 1 Ch 9 Ch17
Pin 13 N/C
Signal Description
I/O 1-8 I/O 1-8 I/O 9-16 I/O 17-24
Pin 14 – Ch 8 Ch16 Ch24
Pin 15 + Ch 7 Ch15 Ch23
Pin 16 shield Ch 7 Ch15 Ch23
Pin 17 – Ch 6 Ch14 Ch22
Pin 18 + Ch 5 Ch13 Ch21
Pin 19 shield Ch 5 Ch13 Ch21
Pin 20 – Ch 4 Ch12 Ch20
Pin 21 + Ch 3 Ch11 Ch19
Pin 22 shield Ch 3 Ch11 Ch19
Pin 23 – Ch 2 Ch10 Ch18
Pin 24 + Ch 1 Ch 9 Ch17
Pin 25 shield Ch 1 Ch 9 Ch17
Signal Description
I/O 9-16 I/O 17-24
ANALOG OUT 1 - 8
12345678910111213
141516171819202122232425
Appendix C: Upgrading the System Software
From time to time, Mackie may release updated versions of the SDR24/96
operating system on our website at www.mackie.com. The file can be downloaded
easily from the SDR24/96 section of the site.
To install new software:
1. Place the SDR24/96 into USB mass storage mode (SETUP:Page
Right:System:USBMS). See “USB mass storage” on page 45 for more info.
2. Connect a USB cable between the SDR24/96 and your computer.
3. Copy the file that you downloaded from the Mackie website from your
computer to the SDR drive that appears on your desktop or in Windows
Explorer.
4. Select Reboot on the SDR24/96.
You are asked to confirm the
upgrade. Select OK to proceed
with the upgrade, or Cancel to
reboot without upgrading.
Upgrade in progress... appears
in the display as the new
software is installed.
Appendix D: Analog I/O Pinout
The analog inputs and outputs on the SDR24/96 are compatible with TASCAM
DB25 analog I/O. See Appendix E for a list of compatible cables.
SDR-1.0-1.0.0
Upgrade? OK Cancel
SDR-1.0-1.0.0
Upgrade in progress...