SRM350v3 and SRM450v3 Powered Loudspeakers OWNER’S MANUAL
SRM350v3 and SRM450v3 Powered Loudspeakers Important Safety Instructions 1. 2. 3. 4. 5. 6. 7. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
Features Important Safety Instructions................................... 2 Contents.................................................................. 3 Features.................................................................. 3 Introduction............................................................. 4 How To Use This Manual.......................................... 4 Getting Started........................................................ 4 Things To Remember..............................................
SRM350v3 and SRM450v3 Powered Loudspeakers Introduction Getting Started The most widely used portable speakers ever; the all-new SRM450 and SRM350 deliver the unparalleled ease-of-use, professional sound quality and indestructible portability that made SRM a live sound legend. Now packed with 1000W of power, the widest selection of truly useful sound-enhancing DSP and setup-friendly audio tools, SRM is ready for your high-output application.
Owner’s Manual Hookup Diagrams SPEAKER MODE FEEDBACK DESTROYER MAIN LIMIT PA SPEAKER MODE FEEDBACK DESTROYER 1 DJ 2 3 SOLO SIG/OL GAIN 2 3 LOGO HOLD TO CLEAR 4 U ON OFF ON SIG/OL GAIN R SOLO L MIC MAX LINE ON OFF LOGO HOLD TO CLEAR 4 U LINE OFF DJ MON ON MAIN LIMIT PA MON 1 MIC OFF MAX CH 1 MIX SIG/OL GAIN GAIN U U LINE MIC OFF SIG/OL MAX LINE R L MIC OFF MAX SPEAKER MODE FEEDBACK DESTROYER MAIN LIMIT PA POWER 1 DJ 2 MON 3 ON OFF ON ON
SRM350v3 and SRM450v3 Powered Loudspeakers Hookup Diagrams continued...
To next SRMv3 loudspeaker input SPEAKER MODE FEEDBACK DESTROYER SPEAKER MODE MAIN FEEDBACK DESTROYER 1 DJ 2 MON 3 SOLO 4 SIG/OL SIG/OL GAIN GAIN U R PA 1 DJ 2 MON 3 SOLO 4 L MIC SIG/OL MAX OFF MIC OFF MAX PA 1 DJ 2 MON 3 SOLO 4 L MAX OFF SIG/OL MIC OFF MAX CH 1 MIX R PA 1 DJ 2 MON 3 SOLO 4 L MAX OFF SIG/OL MIC OFF MAX CH 1 MIX R L U LINE MIC ON OFF LOGO HOLD TO CLEAR GAIN U LINE MAIN ON SIG/OL GAIN U LINE MIC LOGO HOLD TO
SPEAKER MODE FEEDBACK DESTROYER SPEAKER MODE MAIN FEEDBACK DESTROYER LIMIT PA 1 DJ 2 MON 3 SOLO 4 SIG/OL GAIN U MIC DJ 2 MON 3 4 L MIC SIG/OL OFF FEEDBACK DESTROYER R MAX DJ 2 MON 3 LOGO SOLO 4 L 1 SIG/OL SIG/OL GAIN 1 DJ LINE MIC MAX OFF MAX SPEAKER MODE MAIN FEEDBACK DESTROYER PA SIG/OL GAIN R SIG/OL R L U MIC OFF CH 1 MIX LOGO HOLD TO CLEAR GAIN LINE MIC MAX ON OFF ON 2 4 SIG/OL GAIN U LINE OFF 3 SOLO L U MIC MAX 1 DJ MON LOGO
8 9 SPEAKER MODE 10 FEEDBACK DESTROYER As a general guide, SRMv3 loudspeakers should be turned on last, after any mixer or other signal source. As such, they should also be turned off first. This will reduce the possibility of any turn-on or turn-off thumps and other noises generated by any upstream equipment from coming out of the speakers.
DJ 2 SRM350v3 and SRM450v3 Powered Loudspeakers SRM350v3/SRM450v3 Loudspeaker: Rear Panel Features continued... MON 3 SOLO 4 Balanced 1/4" TRS Connector SIG/OL GAIN U RING SLEEVE L 5 U LINE MIC OFF R SIG/OL GAIN Sleeve – Shield (ground) Tip – Positive (+ or hot) Ring – Negative (– or cold) LED HOLD TO CLEAR 4 LINE MAX MIC OFF MAX SLEEVE RING TIP CH 1 MIX RING 3 TIP SLEEVE 6 Balanced 1/4" TRS Connector POWER 5.
SRM350v3/SRM450v3 Loudspeaker: Rear Panel Features continued... For more information on these connectors, see Appendix B on page 17. 7. Ch 1/Mix Switch [Thru Output] This switch allows you to choose whether only the channel 1 signal (pre-gain) is sent out to the next loudspeaker [switch out – Ch 1] or if a mix of the channel 1 and 2 signals are sent out to the next loudspeaker [switch in – Mix] (post-gains).
SRM350v3 and SRM450v3 Powered Loudspeakers Smart Protect AC Power There are advanced DSP protection mechanisms designed into the SRM350v3 and SRM450v3 to safeguard the loudspeakers and amplifiers from inadvertent damage. Be sure the SRMv3 loudspeaker is plugged into an outlet that is able to supply the correct voltage specified for your model. It will continue to operate at lower voltages, but will not reach full power.
WARNING: Installation should only be done by an experienced technician. Improper installation may result in damage to the equipment, injury or death. Make sure that the loudspeaker is installed in a stable and secure way in order to avoid any conditions that may be dangerous for persons or structures. SRMv3 loudspeakers are designed to sit on the floor or stage as the main PA or as monitors. They may also be pole-mounted via the built-in socket on the bottom of the cabinet.
SRM350v3 and SRM450v3 Powered Loudspeakers 14 Room Acoustics SRMv3 loudspeakers are designed to sound fantastic in nearly every application. • Position the loudspeakers so the highfrequency drivers are two to four feet above ear level for the audience (making allowances for an audience that may be standing/dancing in the aisles). High frequencies are highly directional and tend to be absorbed much easier than lower frequencies.
Rigging Hardware and Accessories WARNING: Installation should only be done by an experienced technician. Improper installation may result in damage to the equipment, injury or death. Make sure that the loudspeaker is installed in a stable and secure way in order to avoid any conditions that may be dangerous for persons or structures. Rigging our loudspeakers will invariably require hardware not supplied by us. Various types of load-rated hardware are available from a variety of third-party sources.
SRM350v3 and SRM450v3 Powered Loudspeakers Appendix A: Service Information If you think the SRMv3 loudspeaker has a problem, please check out the following troubleshooting tips and do your best to confirm the problem. Visit the Support section of our website (www.720trees.com) where you will find lots of useful information such as FAQs and other documentation. You may find the answer to the problem without having to part with your loudspeaker.
Balanced XLR Input Connector Balanced 1/4" TRS Connector Each SRM loudspeaker has two female XLR/TRS/TS combo inputs. Be sure the cables are wired per AES (Audio Engineering Society) standards: TRS stands for Tip-Ring-Sleeve, the three connections available on a stereo 1/4" cable. This allows for a direct connection to the channel 1 and 2 input jacks on SRM loudspeakers.
SRM350v3 and SRM450v3 Powered Loudspeakers Appendix C: Technical Information SRMv3 Loudspeaker Specifications Acoustic Performance: Input/Output Frequency Response (–3 dB) 55 Hz – 20 kHz [SRM350v3] 47 Hz – 20 kHz [SRM450v3] Channel 1 Mic-Line 8 k balanced 1/4" TRS, Wide-Z™ Frequency Response (–10 dB) 50 Hz – 23 kHz [SRM350v3] Max peak SPL Channel 2 42 Hz – 23 kHz [SRM450v3] Mic-Line 8 k balanced 126 dB [SRM350v3] 1/4" TRS, Wide-Z™ 128 dB [SRM450v3] Crossover Point 3
Physical Properties Uncle Bill’s Hot Crab Dip SRM350v3: Ingredients: Height 20.8 in / 527 mm 8 tablespoons cream cheese Width 13.1 in / 333 mm 1/2 cup mayonnaise (Kraft Miracle Whip is preferred) Depth 12.3 in / 311 mm Weight 23 lb / 10.4 kg 7 1/2 ounces canned crab meat, drained or 7 1/2 ounces use fresh crabmeat 4 tablespoons minced onions 1 tablespoon fresh lemon juice SRM450v3: Height 26.1 in / 663 mm Width 16.0 in / 406 mm Depth 14.
SRM350v3 and SRM450v3 Powered Loudspeakers SRM350v3 Loudspeaker Dimensions 20.8 in 527 mm 20.8 in 527 mm 13.1 in 333 mm 12.3 in 311 mm WEIGHT 23 lb 10.4 kg 50˚ SRM450v3 Loudspeaker Dimensions 26.1 in 663 mm 26.1 in 663 mm 14.8 in 376 mm 16.0 in 406 mm WEIGHT 37 lb 16.
PA Speaker Mode – This mode is full range, but focuses on mid-range clarity where vocals often reside. Soloist Speaker Mode – This mode features a low frequency roll-off to get rid of unwanted thumps and adds boost and sparkle to mid-range and high frequencies. This mode is perfect for plug-and-play singer-songwriters. DJ Speaker Mode – This mode bumps the lows and highs with a mild tuck to the mids, perfect for music playback.
THRU SRM350v3 and SRM450v3 Powered Loudspeakers 2 1 R RCA L XLR XLR + TRS COMBO XLR + TRS COMBO CH1 MIX -20 dB PAD -20 dB PAD -20 dB PAD Limit + - 0 dB fixed gain GAIN: CCW XLR: OFF TRS (WIDE-Z): OFF RCA: OFF + - Limit | 12:00 | | +20 dB | | 0 dB | | 0 dB | LEVEL CW +40 dB +20 dB +20 dB Limit GAIN: CCW | 12:00 | CW TRS (WIDE-Z): OFF | 0 dB | +20 dB XLR: OFF | +20 dB | +40 dB + - LEVEL ADC ADC ADC LEVEL DETECT LEVEL DETECT Feedback Destroyer DIGITAL BUS Speaker Mode Aco
Please keep your sales receipt in a safe place. This Limited Product Warranty (“Product Warranty”) is provided by LOUD Technologies Inc. (“LOUD”) and is applicable to products purchased in the United States or Canada through a LOUD-authorized reseller or dealer. The Product Warranty will not extend to anyone other than the original purchaser of the product (hereinafter, “Customer,” “you” or “your”). For products purchased outside the U.S. or Canada, please visit www.720trees.
16220 Wood-Red Road NE Woodinville, WA 98072 • USA Phone: 425.487.4333 Toll-free: 800.898.3211 Fax: 425.487.4337 www.720trees.