Owner's Manual
Table Of Contents
- Quick Start Guide
- Owner's Manual
- Contents
- Important Safety Instructions
- Features
- Introduction / Getting Started
- Hookup Diagrams
- Thump GO: Rear Panel Features
- Thump Connect 2 App
- Factory Reset
- Battery Replacement
- Thump Connect 2 App
- Protection Circuitry
- AC Power
- Care and Maintenance
- Placement
- Appendix A: Service Information
- Appendix B: Technical Information
- Limited Warranty
- Product Info
Owner’s Manual
7
Owner’s Manual
Small Club System
USB 1-2
USB 3-4
MUTE
MUTE MUTE MUTE
MUTEMUTE MUTE
USB 1-2
USB 3-4
MUTE
MUTE MUTE MUTE
MUTEMUTE MUTE
Hookup Diagrams continued…
In this example, a ProFX0v3 mixer is connected directly to two Thump GO loudspeakers. It is the perfect setup for a small
club. Simply connect the L/R outputs of the ProFX0v3 mixer to the channel input of each Thump GO loudspeaker.
The gain knob on both should be set to Line. Don’t forget to set the Voicing Mode on both loudspeakers to ‘Music’!
If you desire a little more boom, add a Thump 8S subwoofer to the mix. Here, the L/R outputs of a ProFX0v3 mixer
are connected directly to the channel A and B inputs of the Thump 8S subwoofer. Then the High-Pass Outs of the subwoofer
are connected to the channel inputs of a pair of Thump GO loudspeakers. The gain knob on both should be set to Line.
Here you will want to set the Voicing Mode to ‘Music’.