Owner's Manual

Owner’s Manual
13
Owner’s Manual
Thump GO: Rear Panel Features continued...
6. Overload LED
The Thump GO has a built-in limiter that helps
to prevent the amplifier outputs from clipping
or overdriving the transducers. The limit indicator
illuminates red when the limiter is activated.
It’s okay for it to blink occasionally, but if it blinks
frequently or lights continuously, turn down
the gain knob(s) until it only blinks occasionally.
Excessive limiting may lead to overheating,
which in turn trips the thermal protect
circuitry and interrupts the performance.
See ‘Thermal Protection’ on page 5 for more
information.
7. Battery LED
This tri-colored LED displays the remaining battery
life. The battery life meter is silkscreened on the rear
panel just below the channel 2 combo jack.
The percentages are also listed below:
• Green = 20% – 00% battery life remaining
• Yellow = 5% – 20% battery life remaining
• Red = less than 5% battery life remaining
• No LED = No battery detected
While the remaining battery life may
be seen on the Thump Connect 2 App,
the most reliable method for knowing
the battery status is still via the battery LED
on the rear panel of Thump GO.
Final Thoughts
Just a few final thoughts before we dive into a little
more boring “techy”-type stu. For starters, we would
like to remind you once again that Thump GO works
great on its own, but when paired and connected
with a device using the Thump Connect 2 app, your
world of possibilities really opens up!
Factory Reset
Let’s also talk factory resets. Since settings may
be changed via Thump Connect 2, it may be necessary
to reset the Thump GO to its factory settings.
There are two kinds of resets:
• Sof Reset – Just a simple power cycle will reset
all settings that were previously set via the rear
panel and/or app back to their default settings
(except for Bluetooth and linked speakers that
are stored within Thump GO).
• Hard Reset – A hard reset resets the entire
unit to its factory default, including auto-connect
and auto-link. A hard reset may be accomplished
by pressing and holding down the ‘Voicing Modes’
and ‘Outdoor Mode’ buttons simultaneously
for approximately five seconds on boot up.
Please keep in mind that this erases all
settings, including any levels, EQs, etc. that
may have been set. Be sure to power down
any amps and/or powered speakers before
resetting Thump GO.
If you use the factory default key
combination, you are also wiping the
Thump GO’s memory of previously paired
devices. To remedy this, on your phone,
tablet or other Bluetooth device, you will need to ‘forget
device’ in the Bluetooth settings, then re-pair in
order to regain communication and functionality.
Battery Replacement
The Lithium-Ion Battery allows you to use
Thump GO without the need to be plugged
in or wasting money on expensive batteries.
SAFETY FIRST: Before installing and using
this product, please read these instructions
carefully. Failure to follow the precautions
may result in damage, injury, or even death.
. WARNING: The battery (battery or batteries
or battery pack) shall not be exposed to excessive
heat such as sunshine, fire or the like.
2. CAUTION: Danger of explosion if battery
is incorrectly replaced. Replace only with the same
or equivalent type.