Owner's Manual

Thump GO 8" Portable Battery-Powered Loudspeaker
14
Thump GO 8" Portable Battery-Powered Loudspeaker
3. No open flame sources, such as lighted candles,
should be placed on the apparatus.
WARNING: When installing this product, always
respect the safety standard. Do not install the product
in any way that is not described in these instructions.
BATTERY / COVER REMOVAL INSTRUCTIONS:
Unplug Thump GO and set it upside down on a sof,
flat surface.
Using a flathead or Phillips screwdriver, rotate the
two locking tabs counter-clockwise until they unlock
and “pop” up. Remove the battery compartment cover
and set it aside.
As seen below, the removable battery is surrounded
by the dotted line.
There are finger grips on each side of the battery,
close to where the “battery” text is located.
Remove the battery from captivity by lifing
it straight up to freedom.
BATTERY INSTALLATION INSTRUCTIONS:
Once the battery cover and battery have been
removed and set aside, it’s time to insert a dierent
one.
NOTE: Do not force the battery into place.
There is only one way it fits and there should
be no resistance during installation.
As seen in the drawing above, a vertical power
connector is located in the upper-lef corner from
where the battery is removed. Line up the power
connector of the battery with the power connector
of Thump GO and press down. Again, this is an easy
process; no force is necessary.
BATTERY
Replace the battery cover and lock it to the Thump
GO by rotating the two locking tabs clockwise until
they lock into place.
When not in use, the spare battery
(purchased separately) may be charged
by plugging the included wall adapter
into the power receptacle of the battery
and the other side into a live AC outlet. The battery
will also charge while inside a plugged-in Thump GO.
Thump Connect 2 App
The Thump Connect 2 App was mentioned at the top
of the hour, but is important enough to mention again.
It is designed to be used in conjunction with Thump
GO. With it, all of the hardware features listed here –
and more! – may be controlled remotely via Bluetooth
connection. The only thing the Thump Connect 2 App
can’t do is turn the Thump GO on and o.
More information about the Thump Connect 2
App may be found by visiting the Thump Connect 2
App Reference Guide.
Protection Circuitry
Thump GO employs a built-in limiter for less
distortion at peak levels. A dynamic bass response
circuit provides optimal low frequency response
regardless of overall output level. Additional protection
includes automatic thermal shutdown should the amp
overheat. However, with Class-D amp technology, which
is highly-ecient, this should never be a problem.
The protection circuits are designed
to protect it under reasonable and
sensible conditions. Should you choose
to ignore the warning signs [e.g. excessive distortion],
you can still damage the woofer in the loudspeaker
by overdriving it past the point of amplifier clipping.
Such damage is beyond the scope of the warranty.
Limiting
Let’s take a peek under the hood at the polymer
compression driver. Compared to other available
drivers, these provide a substantially smoother
high-frequency response which results in a studio
monitor level of accuracy and clarity. Furthermore,
these drivers oer an insanely smooth transient
response behavior. Yes, we, too, are fans of our own
products!
Continuing on, the driver has its own compression
circuit which helps protect it from damaging transient
peaks. The compressor is designed to be transparent
and is not noticeable under normal operating
conditions.