quick start Guide to get you up and running straight out of the box
Maclaren is committed to safeguarding the environment by adhering to the principles of: reduce, reuse and recycle. Maclaren encourages consumers to recycle their old Maclaren buggys. Maclaren buggys can be dropped off, or shipped at owner’s expense, to any of Maclaren’s recycling locations below.
It is important that the full instruction leaflet be read and understood. It contains vital warnings for the safety of your child. 1 to open the product 2 to attach the seat IMPORTANT Ensure that all locking devices are engaged before use. This seat must only be used with the GTLX chassis and is suitable for use when your child can sit up unaided. IMPORTANT Check that the seat unit attachment devices are correctly engaged before using the GTLX.
A 6 to operate the harness A To release the harness press BOTH the front and back of the buckle simultaneously. B To fit the harness – Place the shoulder straps over the child’s shoulders and slide onto the waist clips if not already attached. C Insert both waist clips into the clasp, shoulder straps are secured once the clips are fastened. D Adjust strap lengths. Belt and harness should be snug. Re-adjust to suit the recline position if necessary.
8 to fit the soft carry cot — tour lite seat This Soft Carry Cot must only be used with the GTLX chassis and is suitable for a newborn baby. A Ensure the seat is in the rear facing, fully reclined position and the bumper bar is removed. B Slide the adaptors on to the hood insert of the seat ensuring that the locking lever of each adaptor is on the inside of the stroller. C Lock the adaptors on to the hood insert of the seat using the locking levers.
9 to fold the transport system The product may be folded with all items attached however to achieve the best fold without removing the seat, turn the seat to face forward and place it in the most upright position. 1 3 Do not seat a child in the product when it is being folded. A Ensure the Strollometer® is folded behind the instrument compartment. B 1) Pull back on the slider on the left side of the frame – this will latch into position.