User manual

Q: I get Error Code -36

A: The Finder cannot complete the operation because some

data in "smb://storage" could not be read or written.

If you get the above error message, use the IP address instead

of STORAGE. See following steps:

1) Log in via your web browser.

2) Under SMB Server, make sure the folder you want to access

is in the Shared List - for example, the PUBLIC folder without a

password.

3) Go to IP Config, make sure it is set to Automatic IP and write

down the IP address you see there.

4) Go to your Finder and select Go/Connect to Server

5) Type smb://IP/PUBLIC and hit Connect. For the IP use the

IP address you wrote down in step 3, for PUBLIC use the

name of the folder you added to the Sharing List in step 2.

6) If the LAN disk is connected directly to your computer using

the Ethernet cable, the default IP address is 169.254.0.1.

About this Manual

This manual covers all interfaces and combinations for the M9

Enclosure. Images and descriptions may slightly vary between

this manual and the actual product you have.

The information contained in this manual is believed to be accurate and reliable. Macpower & Tytech

Technology assumes no responsibility for any errors contained in this manual and reserves the right to make

changes in the specifications and/or design of this product without prior notice. The diagrams contained in

this manual may also not fully represent the product that you are using and are there for illustration purposes

only. Macpower & Tytech Technology assumes no responsibility for any differences between the product

mentioned in this manual and the product you may have.

- 16 -