User manual

USER MANUAL
M9-SATA USB/LAN
The USB cable ha
to be disconnect
in order for the
network drive to
work. It is not
possible to use both
interfaces at the
same time!
s
ed
To connect the LAN
h,
disk to your network,
an additional switc
router or hub may
be required.
If you connect the
r
may
LAN Disk Setup
To configure your LAN disk, you will need to use a web
ss of your device and then use the
able
same
cal network as your computer.
pen your web browser and type STORAGE or if connected
d
LAN disk to you
computer directly,
make sure to obtain
the IP address and
DNS settings
automatically,
otherwise you
not be able to find
the device.
4
browser, enter the IP addre
web configuration for further setup.
Before trying to access the device, make sure the USB c
has been disconnected and the drive is connected to the
lo
4.1 How to Login
4.1.1 Login on a PC
O
directly to your computer, type 169.254.0.1 into the URL fiel
and hit the Enter key to connect.
same time,
type STORAGE-xxxx, where the xxxx stands for the last four
digits of your Mac address as seen on the bottom of your
device (example STORAGE-2343).
If you have more than one device connected at the
Default Login
Username: admin
Password: admin
ote: We strongly suggest you to change the password as
oon as you are logged in, to prevent unauthorized access.
N
s
Page 8 / Chapter 4 - LAN Disk Setup