User manual

Page 4 / Chapter 2 - Installing the HDD

USER MANUAL

M9-SATA USB/LAN

Be careful not to

Hard Drive Assembly

d the enclosure. Fasten

2.2

Hold the drive in place and turn aroun

the four screws to secure the drive and then turn around the

enclosure again.

damage any cable

or components and

double check the

connection betwee

the cables, the

bridge board an

your hard drive

before you close

the case.

lign the metal sheet cover with the body and push it lightly

into place. Do the same with the top plastic cover to finish the

assembly.

.2.1 Fan Setting

ailable to select the desired cooling.

e recommend using the Auto mode. When this mode is

There are 3 modes av

Automatic (Auto) / Manual Low (M/L)/ Manual High (M/H).

selected, the M9 automatically adjusts the fan speed up an

down as necessary, to keep the HDD cool. Ensure the therma

probe is attached to your drive to use the Auto mode.