User's Manual

5. LetterBox 16:9: Black strips are shown on left and right of the screen.
6. Zoom 4:3 : Expand to right and left to change aspect ratio.
7. Zoom 16:9 : Expand to top and bottom to change aspect ratio.
Display Type
Choose a video output signal of MyHD form either RGB or YPbPr;
RGB for a PC monitor and YPbPr for component output to an HDTV(need a cable for connecting DSUB -15 to RCA).
Video Controls :
- Display Effect: Setting Brightness, Contrast and Saturation of MyHD video output.
To display HD mode, click on Preview button and to exit from the HD mode, click the Esc on the keyboard
- Analog Video: Setting Brightness, Contrast and Saturation of Analog broacasting and external input(composite, S-Video). This
setting applys to overlay screen and Fulll Screen.
- Channel Gain : Controls channel gain. When Display type is RGB, channel gain controls G, B, R output signal gain. And, when
display type is YPbPr, channel gain controls Y, Pb, Pr output signal.
Each display type, RGB and YPbPR, has seperate control over Video Control. Press Default button to return to original default value.
To display Full Screen mode, click on"Preview button and to exit from the HD mode, click the Esc on the keyboard.
Audio Output
1. Cable Out(only for analog broadcasting) :
To use the cable output, audio output of MyHD and a sound card must be connected( refer to Hardware installation). If Cable Out is
selected, audio output of analog broadcasting is worked by a cable even though Wave is checked.
2. Wave : Audio output of digital broadcasting through a sound card without a cable.
Wave must be selected for Audio output of digital broadcasting.
3. SPDIF: SPDIF is used for an Audio Amp(refer to Hardware Settings).
Wave and SPDIF can not be selected at the same time.
Analog Audio
Choose either Stereo or Mono mode.
Bilingual
You can choose Main or SAP only if Mono mode is selected.