User's Manual

To achieve optimum performance of the MyHD Board, your PC requires a following minimum configuration.
CPU : Pentium-II 333MHz or faster
DRAM : 64 Megabytes or more
System Bus : PCI
OS : Windows 98SE, Windows ME , Windows 2000, Windows XP
Other Software : DirectX Media 7.0 or Higher
Graphic Card : DirectX compatible VGA card(8 MB memory or more recommended)
One Available PCI Slot
One 9-pin serial port
*For digital transport stream(ATSC) recording and playback, minimum system requirements are as follows:
CPU : Pentium-III 800MHz or faster
All the other requirements are the same as the above configuration.
This package is including :
- MyHD PCI Card
- Quick Installation Guide
- VGA Loop through Cable with External A/V Connector
- Remote Control Handset
- Remote Control Receiver
- Installation CD
- Audio Card Jumper Cable
- Two 1.5V AAA Batteries
To install MyHD on your Windows 98SE, Windows ME, Windows 2000, or Windows XP system:
Turn off your PC, install the MyHD PCI card, connect the audio jumper cable as needed, and connect the Remote Control Receiver to
a serial port on your PC.
Connect the MyHD PCI card to an external video source and display devices as desired.