User's Manual

Turn on your PC and install the MyHD Windows device driver from the installation CD, then install the MyHD application software.
If DirectX 7.0 or higher version is not installed on your PC, install the latest version of DirectX before the installation of the MyHD
device driver.
Antenna 1
Recommend to connect the antenna lead from your rooftop antenna
Antenna 2
Recommend to connect the antenna lead from your cable antenna
A/V Connector
Connector to connect A/V cable
SPDIF Output
Allows the digital audio output of the MyHD card to be connected to an external audio amplifier.
Audio Output
Allows the analog audio output of the MyHD card to be connected to the LINE IN, AUX or CD input of your PC sound card or motherboard
(using the enclosed jumper cable).
VIP 1.1 Connector
This connector is not currently working.
Warning - Static Sensitive Components
To avoid possible damage to MyHD Board and/or other system components from static discharge, always discharge your body's static
electricity prior to handling MyHD Board or other system components.
Discharging can be done either by using a properly grounded anti-static wrist strap or by simply touching the chassis of a grounded
(plugged-in) computer. In addition, always handle the card by its edges whenever possible, to avoid mechanical damage to delicate
components on the board.
To install the MyHD board, follow the steps listed below:
1. With the power off, remove your computer cover and locate an
available PCI slot.