Operating instructions

GB-27
NAVIGATION OPERATION
The GPS system can navigate with voice, when you do
not drive on your preset line, the system will reset the
line automatically to get the destination.
Press OPEN button on the unit to open the TFT screen,
the SD card slot is on this position (shown as illustration).
It supports SD card with memorized navigation map
only.
Press SRC button on the unit or on remote control
repeatedly to access the navigation mode after insert
SD card witch stored navigating map.
*Long press SRC/NAV button or Touching NAV item on
source selection screen also activate the function
Calibration
To avoid the touching effect function invalid, please
calibrate the touchable screen before perform
navigating operation
Press TOUCH SCREEN button on the touchable screen
and the screen display as following:
Please use something with needle end touching on the
+ button to finish the calibration.
NO TE
Touch the selection displayed on screen to perform the
corresponding operation
For more information regarding the NAV.Operation,
please refer to the user manual of navigating electronic
map.
Please confirm your place is not under the bridge, on
the tunnel or near the building which can infect the
signal received.
For safety, please avoid operate the system while
driving.
GPS system is operated in background at any modes.