Spec Sheet

CM-E1 Specifications

• Voltage: 9-32 VDC

• Current (normal / alarm): 15mA / 35mA @ 9-32V

• Size: 3-1/8 X 5-1/8 X 1-1/2 inch (7.94 x 13.02 x 3.81 cm)

• Alarm Relay: SPST, 100mA, 40VDC

• Trouble Relay: SPST, 100mA, 40VDC

• Buzzer Rating: 85 dBA at 10 Feet

• Shipping Weight: One pound

• Operating Temp. Range: 40°F (4.4°C) to 100°F (37.8°C)

• Alarm Setting: Per UL 2034

• Color: White

• Designed for use with a UL Listed Fire Alarm/Burglary Control Panel

Installation

With the CM-E1 faceplate mounted on the enclosure's rear-housing the unit can be surface mounted on a wall.

A thin mid-plate enclosure component is also supplied with the CM-E1 to mount the CM-E1 on a 2 x 4

inch (5.08cm x 10.16 cm) switch box - single-gang or "handy", provided by the installer.

Location

There are two usual sources of CO - defective heat sources (furnaces or wood burning stoves) and automobiles

running in adjoining garages. The CM-E1 can detect CO from these sources, as well as any other sources of CO.

For best operation, mount a CM-E1 in the hallway near each bedroom or office area. In addition, another CM-E1

may be mounted just inside the door from the adjoining garage. Consider placing another detector in a bedroom

or office that is adjacent to a furnace room. The detector may be installed on either a ceiling or a wall. If installed

on a peaked, gabled, or sloped ceiling, it should be located about 3 feet (1 meter) from the highest point. The unit

can be placed vertically or horizontally on a wall, so the information on the front of the CM-E1 can be read in a

normal manner (not upside down). Do NOT mount the CM-E1 in a corner. Use the same spacing as for smoke

detectors-- 30 foot (9 meters) centers, 900 sq. feet (83 sq. meters) per detector.

Gas Detection Experts

Made in the U.S.A. with US and imported materials

Macurco is a trademark of Aerionics, Inc.

TYPICAL CONNECTION OF TWO CM-E1 TO AN ALARM CONTROL PANEL

TYPICAL COVERAGE 900 SQUARE FEET