Installation Manual

2
TABLE OF CONTENTS
1 Introduction 4
1.1 General Information 4
1.2 Features 4
1.3 Specifications 5
1.4 Warranty 5
1.5 Return Instructions 5
2 Installation & Connection 5
2.1 Mounting the DVP-120 6
2.2 General Wiring Information 6
2.3 Main power Connection 7
2.4 Remote Sensor Connection 8
2.5 Relay Connection 9
2.6 Horn & Strobe Connection 9
2.7 Interfacing Macurco Sensors 10
3 Operation 11
3.1 Initial Operating Mode 12
3.1.1 Status Light Display 12
3.1.2 User Interface 12
3.1.3 Normal Status Display 13
3.1.4 ALARM Status Display 14
3.1.5 Warning Status Display 15
3.1.6 Trouble Status Display 15
3.2 Ventilation control 16
3.2.1 Zone Signal Display 16
3.3 Setting the System Configuration 17
3.3.1 System Menu 18
3.3.2 Configure System Submenu 18
3.3.2.1 Set Time of Day 18
3.3.2.2 Set day of Week 19
3.3.2.3 Load Default Configuration 19
3.3.2.4 Change Password 19
3.3.2.5 Configure Sensor Type 19
3.3.2.6
Enter password 21
3.3.3 Configure Sensors Submenu 21
3.3.3.1 Sensor Summary 21
3.3.3.2 Sensor Type 22
3.3.3.3 Alarm Set Point 22
3.3.3.4 Warning Set Point 22
3.3.3.5 Range 22
3.3.4 Configure Relays, Horn & Strobe Submenu 23
3.3.4.1 Relay Summary 23
3.3.4.2 Relay Mode 23
3.3.4.3 Relay Turn On Delay 23
3.3.4.4 Relay Minimum On Time 23
3.3.5 Configure Horn Submenu 24
3.3.5.1 Horn Summary 24
3.3.5.2 Horn Mode 24
3.3.5.3 Horn Turn On Delay 24
3.3.5.4 Horn Minimum On Time 24
3.3.6 Configure Strobe Submenu 24
3.3.6.1 Strobe Summary 24
3.3.6.2 Strobe Mode 25
3.3.6.3 Strobe Turn On Delay 25