Installation Manual

30
3.3.7.4 Alarm Strobe Signal
A l a r m S i g n a l s
S t r o b e : 1 C o n t i n .
Figure 3-56 Strobe Alarm Signal
This display example shows that the strobe will signal an alarm condition with a continuous signal. The signal definitions are:
– 1 Continuous (default)
– 2 Intermittent, one second on at two second intervals
– 3 Double tap, two beeps at 5 second intervals
– 4 Triple tap, three short beeps at 15 second intervals
– 5 Off, strobe will not flash
3.3.7.5 Warning Signal Summary
The warning signals are in response to one or more sensors indicating gas levels at or above the sensors’ configured warning level.
W a r n i n g S i g n a l s
B u z z
Figure 3-57 Warning Signals
This display example shows that warnings are signaled by the internal Buzzer only.
3.3.7.6 Warning Buzzer Signal
W a r n i n g S i g n a l s
B u z z : 5 O F F
Figure 3-58 Buzzer Warning Signal
This display example shows that the buzzer will not signal a warning condition. The signal definitions are:
– 1 Continuous
– 2 Intermittent, one second on at two second intervals
– 3 Double tap, two beeps at 5 second intervals
– 4 Triple tap, three short beeps at 15 second intervals
– 5 Off, buzzer will not sound (default)
3.3.7.7 Warning Horn Signal
W a r n i n g S i g n a l s
H o r n : 5 O F F
Figure 3-59 Horn Warning Signal
This display example shows that the horn will not signal a warning condition. The signal definitions are:
– 1 Continuous
– 2 Intermittent, one second on at two second intervals
– 3 Double tap, two beeps at 5 second intervals
– 4 Triple tap, three short beeps at 15 second intervals
– 5 Off, horn will not sound (default)
3.3.7.8 Warning Strobe Signal
W a r n i n g S i g n a l s
S t r o b e : 5 O F F
Figure 3-60 Strobe Warning Signal