User's Manual Part 1

[15]

ENGLISH

[14]

® ®

POWER SAVE MODE

If the Headset receives no audio for 15 minutes, the Headset will power down to save

battery power. Press the Power/Sync button to turn the Headset back ON.

WIRELESS RANGE

The Warhead 7.1 Headset transmits audio via digital radio frequency (RF) and has an

operating range of 33 feet/10 meters in any direction. Please remain within this range for

optimal performance. Avoid placing the Base Station on top of a metal surface or behind

other devices that use RF. If the Headset is not operating properly within the 33-foot/10-

meter range, try moving the Base Station to a different location for improved performance.

SYNCING HEADSETS TO BASE STATION

Note: Headsets are paired to the Base Station at the factory. This step is only

necessary when Syncing a new Headset.

With the Base Station powered ON, press and hold the Power/Sync button on the Base

Station for 2 seconds. The Power/Sync LED on the Base Station will ﬂash slowly.

On the Headset, quickly press and hold the Power/Sync button for 5 seconds. The

Headset and Base Station will Sync, and the LED on the Base Station will illuminate solid

when the Syncing is successful.

33ft/10m

ANALOG AUDIO SETUP

Charge the battery and insert it into the Headset. See page 7 for more information.

Plug the 3.5mm stereo audio connector of the RCA Adapter Cable into the Line In input of

the Base Station.

Connect the Red/White RCA cables from the RCA Adapter Cable to the Red/White RCA

cables on the Component/VGA/Composite AV cable. Optional: Connect the male ends of

these cables to the RCA audio inputs on the display.

Connect Power Adapter to Base Station. Plug Power Adapter into wall outlet.

Power ON the Xbox 360 Console and Headset.

To conﬁrm Xbox LIVE settings, press the “Xbox Guide Button” when a game is loaded, and

go to Personal Settings > Voice. Ensure that “Headset Only” is selected.

Press the connect button on the Xbox 360. Press and hold the connect button on the

headset for 3 seconds.

Match the Base Station quadrant to the controller by pressing the Connect button.

See page 18 for more information.

Press the Input button on the Headset to select the analog input. The “Digital” LED on the

Base Station will turn OFF when the analog input is selected.

TRI_476740M02_HD3_UG_16Jan12.indd 14-15 16/01/2012 11:28 AM