Use Guide
Q：What to do if MAD Gaze Watch cannot remote control my smartphone?
A：Please confirm the connection status of MAD Gaze Watch and your
smartphone. A mobile graphic will be shown on the watch interface if the
connection succeeded. Or else, it will be shown as a watch graphic instead.
Open the Detect Mode on Watch, switch off and on again the Accessibility
Service on your smartphone.
Q：Do I need to train my MAD Gaze Watch everytime before use?
A：No. However, if MAD Gaze Watch has been put aside for a long period of
time, we recommend users to retrain the watch as your gesture strength and
positions may vary over time which may affect the accuracy of detecting your
gestures.
Q：After completing the training of MAD Gaze Watch, do I need to retrain the
watch if I would like to switch the user?
A：Yes. As the gesture strength and positions may vary subject to the user,
every user will need to go through the training section before use.
Q：What to do if the gesture detection is wrong or deviated?
A：Open MG Watch on your smartphone, select “Gesture Control Setting” to
retrain certain gesture. MAD Gaze Watch adopts bone conduction artificial
intelligence technology. Please train your watch with similar strength and
positions during the training so as to enhance the detection accuracy and
minimize the system errors.
Q：What to do if I cannot switch to Shortcut Mode?
A：Tap the right side of your forearm twice to enter Shortcut Mode, and your
watch interface will also display accordingly.
Q：Can I pause the gesture control on MAD Gaze Watch?
A：Yes, just simply turn off the Detect Mode on your watch. As long as your
watch is connected with the smartphone, which a mobile graphic is shown on
your watch interface, you can turn on the gesture control anytime by switching
on the Detect Mode again.
Q：How to reconnect my smartphone with MAD Gaze Watch if the connection
was cut off?
A：Please confirm both your MAD Gaze Watch and smartphone have been
switched on Bluetooth. Enter MAD Gaze Controller on your watch, press
“Watch” or “Phone” then press “Reconnect” button. The device icon will be
changed from Watch to Phone.
WATCH USE GUIDELINES (v2020.10) ` Page 36