Installation Instructions

FI_CE_NG_DETECT_LINE_USB_FCC_V1_00US.docx 7/20
To activate the alarm monitoring mode, the control input must therefore be activated at ground potential
(GND) or V + (12-24V). To do this, you must also configure the BPEXT_SENS option in the central unit (using
the "Pc_SNG_Config_Vxxx" software)
Version: Signal Power take-off to ground
2 actions for configuration are to be performed:
Position the switches on the CPU board
Configure the option with the software
Version: Power take-off to 12-24V
2 actions for configuration are to be performed:
Position the switches on the CPU board
Configure the option with the software
.
S2
OFF
3 2 1
ON
Active buzzer
command on
GND
bpext_sens =
1
Active buzzer
command on
V +
bpext_sens =
0
S2
OFF
3 2 1
ON