MH-ST-104 20 : 00 2 or more estimated installation time people required 1
Ok, let’s get started! Put on mood music! To prevent damage to product, use the clean side of package carton or rug as working surface for assembly. In the event of missing or damaged parts, delivery problems etc., please reach out to our team.
care guide Clean regularly with a soft and dry cloth. To protect finish, avoid use of abrasive cleaners. Wipe up spills immediately. Please! While assembling the product, tighten the bolts up to 50%. Once all parts are in place, only then fully tighten the bolts.
product parts A, C Shelf Leg x2 B, D Shelf Leg x2 E Support Rod x2 F Shelf x1 G Shelf x1 H Shelf x1 I Shelf x1 4
what’s included (J) - Flat Washer (Ø20mm x Ø8.
assembly instructions Friendly Tip: Take a deep breath going in. This may be a tricky part, but nothing too overwhelming. Just follow these steps to the T and the outcome will be worth it! While assembling the product, tighten the bolts up to 50%. Once all parts are in place, only then fully tighten the bolts.
step 1: Begin assembly by joining the support rods (A, B, C & D) to each other. A with B and C with D as shown in the image below. A C B D step 2: Using the allen key (O), tighten screw (N) on holes in the support rods as shown below.
step 3: Now add top and bottom rods (E) at the spaces highlighted below. E E step 4: Using the allen key (O), tighten screw (M) on holes in the support rods (E) as shown below. This will fix the support rods (E) to the shelf legs (A, C) (B, D).
step 5: Place all the shelves (F, G, H, I) at their respective places (In an increasing order from the top). Using allen key (O), tighten screw (L) & washers (J & K) on holes in the support rods as shown below. J F G K L H I O step 6: Assemble the metal brackets (R) in predrilled holes under the shelf as shown in the image. Use screws (S) to do this.
installation instructions While assembling the product, tighten the bolts up to 50%. Once all parts are in place, only then fully tighten the bolts.
step 1: Place the assembled ladder shelf against the wall and put a spirit level on the top plank to check alignment. Adjust if needed. Stand back to see if both the legs are in level with the wall. Then, taking this image as reference, mark the top of the legs on the wall. step 2: Next, measure the distance between the top of the legs and the keyhole slots using a measuring tool.
step 3: Taking the distance on the measuring tool as reference from the first mark, make a second mark for drilling. step 4: Drill holes on the mark and insert wall plugs (P) and screws (Q). Now, align keyholes with the screws.
step 5: Next, to install the assembled ladder shelf, make marks on the wall with the help of a pencil where you want to make holes. See the highlighted areas to understand step 6: Drill holes and insert the wall plugs (P) completely in the wall. Now insert screws (Q) and tighten using a screwdriver.
