Wireless LAN Security Smart Wireless PCI Adapter 802.11b (95-20) User Guide 100-409-01 Copyright © 2002 Madge Networks. All rights reserved.
Federal Communication Commission Interference Statement This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Contents 1 2 3 4 5 6 7 8 Introduction............................................................................................................................................ 1 1.1 Features .......................................................................................................................................... 1 Package Contents................................................................................................................................... 1 System Requirements .......
1 Introduction The Madge PCI adapter (95-20) is a high-performance PCI-to-PC Card adapter, which supports one PC Card socket. It is compliant with the 16-bit PC Card specification defined in PCMCIA Release 2.1/JEIDA 4.1 and 32-bit CardBus; it can support any 8-bit/16-bit/32-bit PC Card in one socket, powered at 3.3V/5.0V as required. The PCI adapter provides a rich set of features, which make it a good choice for bridging between PCI and PC Card in desktop computers.
3 System Requirements 3.1 Hardware Requirements IBM PC Compatible Computer One free PCI Expansion Slot 3.2 Software Requirements The PCI adapter is compatible with the following operating systems: Microsoft Windows 98 Microsoft Windows 98SE Microsoft Windows Me Microsoft Windows 2000 Microsoft Windows XP 4 Software Setup NOTE: If your system is Windows XP, you can skip this chapter. 1. Power on your computer with Windows 98/98SE/Me/2000. 2.
. Click the Install driver for PCI Adapter 802.11b (95-20) link to run the setup program. Now go to Step 9. 7. If the AutoPlay capability of the CD-ROM drive is disabled, click the Start button on the taskbar, click Run, and then the Run dialog box appears. 8. In the Open text box, type in D:\Setup.exe (where D: is the CD-ROM drive letter) to run the above setup program. Now go to step 5. 9. The welcome dialog box appears. Click Next to continue. 10. The Software License Agreement dialog box appears.
wireless LAN adapter. The front of the PCMCIA adapter (which has the LED and “Smart Wireless” label on it) must be inserted such that it is next to the PCI adapter’s circuit board as follows: 7 Specification PCI Local Bus Specification Revision 2.1 compliant. PCMCIA 2.1, JEIDA 4.1, and CardBus compliant. 3.3V/5.0V operation. Intel 82365SL register compatible, ExCA compatible. ATA disk interface support. Supports Hot-Swapping—inserting and removing a PC Card without shutting down system.
