User's Manual

Appendix A

A-1: Default Settings

TIP: Press the Default (SF-Reset, or Soft-Reset) switch on the housing of a powered-on AP to reset

the configuration settings to factory-set values.

Setting Name Default Value

Global

User Name root

Password root

IEEE 802.11b

Regulatory Domain FCC (U.S.)

Channel Number 11

SSID wireless

SSID Broadcasts Enabled

Transmission Rate 11Mbps

Transmission Power High

MAC Address See the label on the accompanying

PCMCIA card or the label on the housing

of the AP.

Security Mode Open System

Selected WEP Key Key #1

WEP Key #1 00-00-00-00-00

WEP Key #2 00-00-00-00-00

WEP Key #3 00-00-00-00-00

WEP Key #4 00-00-00-00-00

MAC-Address-Based Access

Control

Disabled

Access Control Table Type Inclusive

IEEE 802.1x/RADIUS Disabled

LAN Interface

Method of obtaining an IP Address Set manually

IP Address 192.168.0.1

Subnet Mask 255.255.255.0

Default Gateway 0.0.0.0

Management

SNMP Enabled

UPnP Enabled

A-2: LED Definitions

There are several LED indicators on the housing of an AP. They are defined as follows:

l ALV: Alive. Blinks when the AP is working normally.

l RF: IEEE 802.11b interface

l LAN: Ethernet LAN interface

l PWR: Power