Installation Instructions

EMC compliance statement

The statements on this page apply to the following adapters:

• Smart 100/16/4 PCI Ringnode

• Smart 16/4 PCI Ringnode Mk2

• Smart 16/4 PCI Ringnode Mk3 (WOL)

• Presto PCI 2000

• 16/4 CardBus Adapter Mk2

• Olicom RF 3540

• Olicom RF 3140

• Olicom RF 3140v2

• Olicom RF 3141

• Olicom OC 3137

• Olicom RF 3139

• Olicom GC 3250

• Olicom GC 3221

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

• this device may not cause harmful interference

• this device must accept any interference that may cause undesired operation

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• reorient or relocate the receiving antenna

• increase the separation between the equipment and the receiver

PAGE 1
EMC compliance statement The statements on this page apply to the following adapters: • Smart 100/16/4 PCI Ringnode • Smart 16/4 PCI Ringnode Mk2 • Smart 16/4 PCI Ringnode Mk3 (WOL) • Presto PCI 2000 • 16/4 CardBus Adapter Mk2 • Olicom RF 3540 • Olicom RF 3140 • Olicom RF 3140v2 • Olicom RF 3141 • Olicom OC 3137 • Olicom RF 3139 • Olicom GC 3250 • Olicom GC 3221 FCC Statement This device complies with Part 15 of the FCC Rules.
PAGE 2
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected • consult the dealer or an experienced radio/TV technician for help The user is advised that any modification to the board not expressly authorised by the manufacturer may void the user's authority to operate this device. Canadian Statement This Class A digital apparatus meets all the requirements of the Canadian InterferenceCausing Equipment Regulations.