User Manual

Page 13

MadgeTech RTDTemp2000

5.4 Units

Pressing the F3 key while viewing the Main Screen will access the Units Selec-

tion screen. Here the measurement units can be easily changed. In the Units

Selection screen the F1 function key corresponds to the external probe chan-

nel. Selecting this channel by pressing its corresponding function key allows

the user to change the units by either pressing the function key repeatedly

or using the UP and DOWN keys to scroll through the list of available units.

Selecting ok (either by pressing the OK button or the F4 key) accepts and

conﬁrms the unit selection. Pressing the CANCEL key cancels the unit chang-

ing action and reverts to the previously selected units. The RTDTemp2000

offers most commonly used units.

5.5 Setup Menu

Pressing the F4 key while in the Main Screen will display the Device Con-

ﬁguration screen. From this menu, changes can be made to most of the

RTDTemp2000’s display conﬁguration including the screen contrast, size

of the channel view in the main screen, as well as display of the channels.

Power status can also be viewed including battery power remaining and the

presence of external power, and options regarding the LCD display and the

backlight can be modiﬁed. The setup menu is also the place to ﬁnd basic

information regarding device identiﬁcation, calibration parameters, and

ﬁrmware details.

5.5.i Display

From the Display section, the number and identity of channels shown on the

main screen can be changed and set, the LCD screen’s contrast values can be

changed and set, and the size the channel information appears on the main

screen can be changed and set. Pressing F1 while in the Setup Menu brings

up the Display section.

5.5.i.a Adjust Visibility

The ﬁrst screen that appears in the Display section is the Adjust Visibility

screen. Here the F1 key corresponds to the external probe channel.

Pressing F1 results in highlighting its corresponding channel function

tab. While the channel is highlighted the corresponding display function

can be toggled between “Hide” and “Show”, with “Hide” indicating that

the channel will not be displayed on the main screen and “Show”

indicating that it will be shown. Channels can be toggled by either

repeatedly pressing the channel’s corresponding function key or by using

the UP and DOWN keys.