Use and Care Manual

ManualsBrandsMadison Park ManualsRoman ShadesLyndon Natural Ash 35 in. W x 64 in. L Bamboo Light Filtering Roman Shade

CORDLESS

BAMBOO SHADE

INSTALLATION

INSTRUCTIONS

CHECK COMPONENTS

Up to 35in.

Shade

Width

Size

Mounting

Bracket

Screw Anchor

2 4 4

PRESS

PREPARE NECESSARY TOOLS

- Screw Driver

- Pencil

- Hammer

- Measuring Tape

- Drill / Drill Bits

- Ladder

Wall or Outside Mount

(A minimum 1/2 inch ﬂat wall space is necessary)

STEP 1 – DETERMINE INSIDE / CEILING,

FLUSH, WALL or OUTSIDE MOUNT

Inside/Ceiling or Flush Mount

(A minimum 1 inch depth is required or 2 inches depth for ﬂush mounts.)

1. Position brackets approximately 2 inches from the ends

of the headrail.

2. Mark the bracket locations upward through the holes

with a pencil.

3. Use the screws and anchors in the top bracket holes to

attach your brackets.

1. Position brackets approximately 2 inches from the ends of the

headrail. If your shade had a third bracket provided, position

middle brackets to align with pre-drilled holes in the headrail.

2. Mark the bracket locations through the rear holes with a pencil.

3. Use the screws and anchors in the rear bracket holes to

attach your brackets.

Step 1 Step 2 Step 3

2 inches

Step 1 Step 2 Step 3

2 inches

CLEANING and CARE

To clean your shade, use a feather duster, microﬁber cloth or

vacuum lightly using the soft brush attachment.

Do not use any harsh chemicals or water to clean, natural bamboo

wood material will be damaged over time from excessive moisture.

STEP 2 – ATTCHING SUPPORT RODS

Swing the support rods into the square brackets that are attached

to the back of shade. Snap on place by pressing ﬁrmly and click

support rods together.

STEP 3 – MOUNTING THE SHADE

1. Attach front lip of the headrail into the front hook of each

mounting bracket.

2. Rotate and push headrail back into the mounting brackets

until it clicks into place.

Step 1

Step 2

Front Lip

Spring Tab

STEP 4 – HOW TO OPERATE

To Lower The Shade:

Grip the bottom rail and slowly pull straight down.

To Raise the Shade:

Put one hand at the bottom rail (palm facing up) and lift slowly

until the desired height is reached.

Important Note:

Always push and pull at the center of the shade to assure that

the bottom of the shade remains even (i.e. parallel to the top of

the shade). If the shade becomes uneven, slowly pull it all the

way down, and then lift to the desired position. If your shade is

stuck, carefully look at the back of your shade and untangle any

cords that appear tangled.