Specifications

If the CDD senses an obstruction during opening of the drawer mecha-

nism, it will attempt to re-close. If successful, it will read the disc’s table of

contents and display the disc’s number of tracks and total time (followed by

the playlist’s track and time information, if one exists). If for any reason the

drawer does not close fully, it will stop where it is and wait for your inter-

vention. After removing the obstruction, press the stop/drawer button again

to close the drawer normally.

Similarly, if the CDD senses an obstruction during the closing of its drawer

(as might be caused by an improperly seated CD, or an inquisitive child’s

finger), it will stop immediately and attempt to reopen. If the nature of the

obstruction prevents this also, it will stop where it is and wait for your inter-

vention. After removing the obstruction, press the

stop/drawer button again

to close the drawer.

11 STOP/DRAWER BUTTON

Pressing this button once while a disc is playing will stop the disc, resulting

in the total number of tracks and the total time on the disc being displayed.

(Both the time on disc and the time remaining LEDs are lit to clarify the

meaning of the information being displayed at this point.)

Pressing this button once the disc has stopped, or if there is no disc in the

transport, will cause the drawer to open. If the disc is still playing, you may

press the button twice rapidly, to effect both the stop command and the

drawer open command; the CDD will remember the second button push

and execute it as soon as the disc has stopped spinning.

Pressing the stop/drawer button will cause an open drawer to close. If it

senses a disc in the drawer, the CDD will take a moment to read the disc’s

table of contents so that it may display the total number of tracks and the

total time on the disc for your information.

Finally, pressing and holding the stop/drawer button while the CDD is

stopped will display the version number of the operating software and its

checksum. This “hidden feature” allows you to double-check the version

number and integrity of the software in your unit without having to open it

up, should this ever become necessary.

12 REPEAT BUTTON AND INDICATORS

You may choose to either repeat the entire disc (including any programs

you might have entered for that particular disc) or an individual track by

pressing the repeat button. From normal operation, the first press of the

repeat button will light the disc LED below the display (number xx in the

front panel illustration). Pressing the repeat button again will light the track

LED (number xx in the front panel illustration). Pressing it a third time will

cycle out of any repeating mode, as will pressing stop/drawer at any time.

In either case, both repeat LEDs will be extinguished.

The disc repeat LED is lit when the CDD is set to repeat a disc (or a disc’s

program, if it has one) endlessly.

The track repeat LED is lit when the CDD is set to repeat a single track

endlessly.