User guide

Geometry ➤

Functions

Geometry functions are accessed through the Geometry

menu. To display this menu, press .

Note: It is usually easier to adjust display geometry while

a test pattern ( ) is displayed.

Size

The Size function is used to adjust the horizontal and

vertical size of the display image. (This adjustment is

also available through the Picture menu).

To adjust size, select Size from the Geometry menu. Two slidebars are dis-

played: a Horizontal Size slidebar and a Vertical Size slidebar. Press

to adjust vertical size, and or to adjust horizontal size until the objects

within your picture have the proper shape. For example, if there is a circle in

your picture, size should be adjusted so that the circle is round, not oval.

Note: The Size function should not be used to compensate for aspect ratio mis-

matches between source images and the projection screen. Not all sources use the

same aspect ratio therefore it may not always be possible to fill the entire screen.

(“Aspect Ratio” is defined in Appendix A).

Keystone

The Keystone function adjusts side keystone geometry distortion. Adjust

keystone to change the width at the top of the display in relation to the

width at the bottom. The displays below demonstrate keystone adjustment.

To adjust keystone, select Keystone from

the Geometry menu then press or to

adjust the top and bottom widths of the

display as desired.

Side Pin

The Side Pincushion function adjusts pincushion of the sides of the display

image.

The two displays shown below demonstrate side pincushion adjustment.

To adjust side pincushion, select Side Pin

from the Geometry menu then press

or until the sides of the image are

as curved or as straight as desired.

GEOM

OPERATION

3.24