User manual

Using The Software 154

Use "New" to create a new layer with default settings. Use "Duplicate" to reproduce the

selected layer, which will add a copy/a new layer with the same setup next to it. Use "Copy" to

store the settings of the selected layer to the clipboard. Then, use "Paste" to apply the stored

settings to the layer you have currently selected. This does not create a new layer, but

overwrites the settings. Click "Insert" to create a new layer using the settings stored in the

clipboard. "Rename" can be used to change the description of a layer tab. Then, hit "Enter" to

accept the changes. Use "Delete" in order to remove the layer in use from the effect.

Layer Opacity

You can use opacity to create overlapping layers. The opacity

fader determines the opacity of the currently selected layer. You will get 100% coloring by pulling

the layer to the far right. A value of 127, i.e. the middle position, sets the opacity to 50%.

You can also use the input field to enter a certain value. The values range from 0 to

255, the highest value with zero opacity.

Tip: If you double-click the fader area (using the left mouse button), the slider will position

itself at 50% opacity.