User manual

OUTPUT 320

Even if your Art-Net hardware does not support Pre Sync or Post Sync mode, it might

be advisable to activate it in MADRIX. In this way, data packages will be sent one

after another and will not get mixed up. The data will be sent more precisely. But

please make sure that all of your interfaces are available in the network.

Click "Sync" and a new dialog will open. Now, choose if you want to activate sync packages to

be sent before data is sent ("Pre Sync"). Or you can send sync packages after Art-Net data has

been sent ("Post Sync"). Then, press "OK".

If you want to disable sync mode, click "Sync" again and uncheck the mode that is selected.

Then, press "OK".

Detailed information is described in the chapter Technical Information For Developers.

Config By Web

The button "Config By Web" allows you to configure your Art-Net device

remotely with the help of a web browser if this feature is supported by your device. If this feature

is available, a new browser window will be opened using the specified IP address. This offers you

access to the configuration dialog of your Art-Net device. If this is not possible, a message box

will be displayed in MADRIX.