User manual

MADRIX Help and Manual399

Enable DMX-OUT

Please make sure that your DMX devices are enabled. Select the interface or multiple interfaces

and click "Enable" and "Apply".

A green dot in the list indicates that all devices are enabled and working. If the

"State" is "off", please click "Enable" in the "Settings" section.

Setting up the "Frame Time" is particularly useful if you have connected different devices each

rendering different output frame rates and you want to sync them to a specific frame rate. OR it

might be that the LED fixtures you attached have problems with fast frame rate. You are able to

slow down the frame time by typing in larger values in ms in that case.

Please note: If you are loading a MADRIX Setup, please check if the number of ACN devices in

your setup corresponds with the number that is activated. The Setup stores the number of

devices. But if you changed the amount and then loaded the Setup, the newly defined number will

be activated.