User manual

MADRIX Help and Manual407

Use "Set Frame Time (ms)" in order to set a different frame time. By default, the DVI device is

set to be an "event" type with a frame rate of 50 FPS. If you manually set a new frame time, the

output might judder. We do not recommend to set a higher frame rate than 50 FPS. But if your

hardware controller requires a frame rate that is lower than 50 FPS, adjust the value to these

requirements. Then, the type of your device will be set to "frame" in the list.

"Remove Device" will delete the currently selected DVI device.

"Highlight Device" will make your device flash and will set all pixels instantly to white for testing

purposes.

"Configure Device..." will call up the configuration dialog, again.

Further Configuration

Please remember to configure your light matrix in the Matrix Generator or Patch.

Please make sure to save your MADRIX Setup after the configuration process.

Important Notes

Device Type

Comments

All DVI device types

1) Please do not use a network hub or switch. Please only use a

direct network connection.

2) Please note that the hardware controller needs to be

configured correctly, before MADRIX can be used.

3) The configuration cannot be rotated. If you have rotated

fixtures in your installation, please use the rotation features

provided by each MADRIX effect.

EuroLite T9

1) Before using MADRIX, please make sure that you have

configured your EUROLITE LED fixture and hardware correctly.

The configuration is described in the EUROLITE user manual.

Repeat the steps if necessary.