User manual

OUTPUT 408

2) You can only create and use one single DVI device in MADRIX

per network card. This means that a maximum of 56 controllers

connected in series can be used per one network card with a

maximum of 128x128 pixels for each controller.

3) Please note: Configure only one hardware controller at a

time with the software EUROLITE LED Show T9. Please do not

connect several controllers while setting the parameters.

4) See www.eurolite.de for the latest documentation.

Checklist To Solve Problems

If you are encountering problems, please work through the following checklist:

Please check if all network cables are connected correctly. Please do not use a network hub or

switch.

Please check if your hardware is working without MADRIX.

Please check if you have installed the "WinPcap" Driver during the installation of MADRIX.

Please check if your light matrix is configured correctly in the "Matrix Generator" or "Patch".

Please go to the menu "Preferences" -> "Device Manager". Check if you have added a new DVI

device under "DVI Devices".

Please check if "Enable" and "Enable Full Size" are activated for your device in the "Device

Manager" under "DVI Devices".

Please configure your hardware controller again if this seems to be necessary.

Please always configure only one hardware controller. Do not connect two or more controllers

while setting the parameters.