User manual

MADRIX PLEXUS 576
© 2011 inoage GmbH
"Repeat"
defines how often the Scene is repeated. Simply enter a number. A value of 0 will
be shown in the list as "Endless", that means it will be repeated endlessly.
"Soft Loop"
creates an automatic loop by the software. First, enter a number of frames.
MADRIX will add these frames to the end of the Scene and therefore loops towards
the first frame of your Scene. A cross-fade is created. For example, if your record
was set to a frame rate of 33 FPS and you enter 66 here, the last two seconds of
the Scene will be used for a loop towards the first frame.
"Follow"
defines which Scene will be played after the currently selected Scene. Applicable
values are: "No", "Next", and a specific Scene ("1", "2", "3", etc).
"Master"
defines the Master Fader for the Scene in percent, that means the master
brightness. Applicable values are: 0 - 100.
"Speed"
defines the tempo in percent. Applicable values are: 0 - 1000.
"Port7"
defines if Port 7 of the Extension Port will be triggered when the Scene begins to
play. Applicable values are: "NO", "0" (OFF), or "1" (ON).
"Port8"
defines if Port 8 of the Extension Port will be triggered when the Scene begins to
play. Applicable values are: "NO", "0" (OFF), or "1" (ON).
"Port9"
defines if Port 9 of the Extension Port will be triggered when the Scene begins to
play. Applicable values are: "NO", "0" (OFF), or "1" (ON).
"Port10"
defines if Port 10 of the Extension Port will be triggered when the Scene begins to
play. Applicable values are: "NO", "0" (OFF), or "1" (ON).
Timers:
The tab "Timers" allows you to add specific events to your Stand-Alone Show.
First, please select one PLEXUS Configuration you wish to edit.