Instruction Manual

ManualsBrandsMag Layers USA ManualsHardwareRT12P15

Networking Communication Components

RT Series

Lan Transformer

Part number: RT12P15

Part name :Giga Transformer Single Port

●

Compliant and peak reflow temperature rating 245°C .

●

Meets IEEE802.3 specification.

●

Packaging specification is reel.

(

RT12P

□□

: Reel )

Part number code

RT 1 2 P □□

Serial number

Type

Application Category

Ports

Product Symbol

Feature

Summary of content (5 pages)

PAGE 1
Networking Communication Components RT Series Lan Transformer Part number: RT12P15 Part name :Giga Transformer Single Port Feature ● Compliant and peak reflow temperature rating 245°C . ● Meets IEEE802.3 specification. ● Packaging specification is reel.
PAGE 2
REV. A Description Specification issued Date Drawn Designed Approved 02.01.2013 Yuxuan.Xiang Yuxuan.Xiang James.
PAGE 3
Mechanical Dimension and Marking A RT12P15 B Date Code UNIT A B C D E F G mm 15.10 +0.254/-0.254 9.00 +0.254/-0.254 4.00 +0.254/-0.254 1.00 +0.127/-0.127 0.50 +0.127/-0.127 11.00 +0.254/-0.254 6.50 +0.254/-0.254 inch 0.594 +0.010/-0.010 0.394 +0.010/-0.010 0.157 +0.010/-0.010 0.039 +0.005/-0.005 0.020 +0.005/-0.005 0.433 +0.010/-0.010 0.256 +0.010/-0.010 RT12P15 XX XX Maglayer Part Number Week Year C D E F G Suggested Land Pattern a UNIT d b c mm inch a 11.00 0.433 b 9.90 0.
PAGE 4
Schematics RT12P15 CABLE SIDE CMT1 TX1+ TX1- CMT2 TX2+ TX2- CMT3 TX3+ TX3- CMT4 TX4+ TX424 23 22 21 20 19 18 17 16 15 14 13 1 2 3 4 5 6 7 8 9 10 11 12 TCT1 TD1+ TD1- TCT2 TD2+ TD2- TCT3 TD3+ TD3- TCT4 TD4+ TD4- PHY SIDE Electrical Specification @ 25°C, Humidity 65% RH Inductance @ Phy side(OCL) 100KHz, 0.1V, 8mA DC Bias 350uH MIN Turns Ratio Part Number 100KHz RT12P15 ± 3% 1:1 Insertion Loss dB MAX 1MHz-100MHz -1.
PAGE 5
Reflow Soldering 3°C /sec MAX. 245°C 217°C 200°C 150°C Pre-heating 53sec TYP. 60sec MIN. 180sec MAX. Soldering Temperature(°C) 6°C /sec MAX. 60sec MIN. 150sec MAX. Time(s) ● IR Reflow soldering : ● ● ● ● ● Preheat at 3℃ per second to 217℃ and using lead free solder , IR at 245℃ for 30seconds Max. Rework flow: Component must withstand two IR reflow cycles with a cool down between cycles Temperature is measured at the terminal portion of product (Using thermocoupler for measurement).