User's Manual

3
Fundamentals 2
Powering on the Magellan RoadMate
receiver
The Power On/Off switch is located on the top
of the Magellan RoadMate receiver.
Turning the Magellan RoadMate receiver
On
1. Press the power switch.
2. After the initial splash screen the
Warnings screen is displayed. Read and
tap
.
Turning the Magellan RoadMate receiver
Off
1. Press the power switch. The receiver will
automatically power off in 15 seconds.
[Cancel] cancels the power off sequence
and returns to last viewed screen.
[Power Down Now] turns the receiver
off immediately, bypassing the 15 second
delay.
Note: Anytime the power cable is
disconnected from the receiver or if power is
turned off at the 12v power receptacle, the
receiver will begin the power off sequence.
Vehicle Profile
The first time you power on the device you will
be given the opportunity to enter the Vehicle
Profile. Note that you can change this at any
time by accessing the vehicle profile icon from
the Main Menu.
The Vehicle Profile Menu provides access to
the six different vehicle details that are used by
the Magellan RoadMate. If you are going to
enter your vehicle information please note that
you must enter the height, width and length
as a minimum.
If you are not going to use the Vehicle
Profile, uncheck the Set Vehicle Profile box to
continue.
2.
Battery Levels
The Magellan RoadMate receiver has an
internal battery that is charging whenever
the receiver is connected to external power.
Note: The battery can only be serviced by
authorized Magellan repair facilities.
Viewing the Battery Level Indicator
1. While viewing the Map screen, tap on the
Menu button in the right corner.
2. The battery level indicator is located in
the upper right corner of the Main Menu,
just below the satellite signal indicator.
Green bars indicate battery level.
Speaker Volume
Changing the Volume from the Map
Screen
1. Tap the speaker icon . Additional controls
appear.