User Guide

Installation

System Requirements

Minimum Requirements

IBM PC, AT-486 or compatible

64 MB RAM

VGA Video Card

120 MB Hard Drive Space

CDROM Drive – 8x speed

MS Windows 95/98/ME, NT/2000

Recommended Requirements

IBM PC, AT-Pentium/300 or compatible

128 MB RAM

True Color Video with 800x600 resolution

120 MB Hard Drive Space

(700 MB Hard Drive Space for a full installation)

CDROM Drive – 32x speed

MS Windows 95/98/ME, NT/2000

Connecting the GPS Unit

Connecting the Cable to the GPS Unit

There are two configurations for connecting the cable to the GPS Unit. One is while the GPS

Unit is mounted in the swivel mounting base and the other is when the GPS Unit is a

standalone receiver. Both methods are similar and are shown in the accompanying

drawings.

Mount to the back of the Swivel Mounting Bracket

Using the two screws included, attach the

connector to the back of the swivel-mounting

bracket. It is not necessary to tighten the

captive screw to the unit, although you may

do so for added security

Mount to the back of the GPS Unit

PAGE 1
Installation System Requirements Minimum Requirements IBM PC, AT-486 or compatible 64 MB RAM VGA Video Card 120 MB Hard Drive Space CDROM Drive – 8x speed MS Windows 95/98/ME, NT/2000 Recommended Requirements IBM PC, AT-Pentium/300 or compatible 128 MB RAM True Color Video with 800x600 resolution 120 MB Hard Drive Space (700 MB Hard Drive Space for a full installation) CDROM Drive – 32x speed MS Windows 95/98/ME, NT/2000 Connecting the GPS Unit Connecting the Cable to the GPS Unit There are two configu
PAGE 2
Using the captive screw that is attached to the connector, tighten into the back of the unit (mounting screws are not used) Connecting to the PC Connecting the Cable to your PC Disconnect power from your personal computer and connect the other end of the data cable with the DIN-9 connector to an available COM-port. Remember which port you are using as you will need this information for a successful transfer of map data to the GPS Unit.