Installation manual

Magellan 45
Tabletop Mounting
Figure 14: Tabletop Mounting
To mount the Magellan console on a tabletop
the wall plate has to be inserted beforehand:
1. Slide the wall plate’s tabs labeled B into the
Magellan console’s open slots labeled D
(see Figure 13 on page 44).
2. Insert two screws (included) through the wall
plate’s screw holes labeled C into holes
labeled E in the Magellan console (see
Figure 13 on page 44).
3. Insert the two plastic feet (included) into the
appropriate holes on the back plate of the
Magellan console as shown at left.
4. Attach the two rubber stops (included) to the
lower corners of the wall plate as shown at
left.
Wall plate
Plastic feet (x2)
Rubber stops (x2)
Tabletop
Back view of the
Magellan console.
The plastic feet are used to raise the
Magellan console to a slight angle for
easy viewing while the rubber stops
prevent the console from sliding when
Magellan is being used.
Tabletop mounting may not be an
approved installation method by
local regulations. It is recommended
that the local regulations be verified
prior to installing the Magellan
console using this method.