Installation manual

SYSTEM ACTIVATION

STEP 1 - CHECK ALL CONNECTIONS

Make sure all of your wires are connected properly from the MAGELLAN Hardware Installation.

Below is a schematic of a correctly connected MAGELLAN system.

There are 5 cables that come down from the MAGELLAN that connect to 3 different components.

1. The RX Coax Cable that connects to the DW6000 Modem

2. The TX Coax Cable that connects to the DW6000 Modem.

3. The Ethernet Cable that connects to the Router (Port 1-4).

4. A Phone Cable that connects the remote control.

5. Power Cable that supplies the dish with 15VDC power (via a supplied 15V Power Supply)

The MAGELLAN was designed to work well when all components are turned off and on from a power

bar switch. Note that a computer is not part of the MAGELLAN system. Also the MAGELLAN is a

self-contained Wi-Fi satellite system, which means that all components may be located in the same

cabinet and not necessarily where the computer workstation(s) located.

DRYDOCKING - For those who need to draw as little power as possible, the customer may turn off just

the MAGELLAN (by simply unplugging it) and it will not affect surfing traffic. Of course the dish must

have acquired satellite before it can be unplugged.