User guide

Installation
MultiView™ II DVI-TX Installation and User Guide 12
4.3 Configuration
4.3.1 User-Configurable Settings
The DVI-TX has a number of configurable operating parameters, and the factory-default settings will work in
most applications. However, some applications may require configuration changes. Nearly all settings are
available from the front-panel buttons/LEDs. The enclosure does not need to be opened unless an option
module is being installed or removed, or settings specific to the option module need to be changed.
The DDC MODE selection is done in NORMAL operating mode (CFG indicator is off).
 Just press the DDC MODE button to change the DDC operating mode.
For all other configuration settings, the DVI-TX must be in CONFIG mode (CFG indicator is on). Once in
CONFIG mode, any changes are effective immediately and are saved in non-volatile memory.
 To enter configuration-mode: Press CFG button once. The CFG indicator will turn on, confirming
you are in configuration-mode. Once in this mode, the LED indicators 1-8 will display the current
settings as described in the tables below.
 To exit configuration-mode: Leave the buttons untouched for 10 seconds. The CFG indicator will
turn off (normal-mode).
To quickly reset all user-configurable options back to factory-default settings:
 Disconnect the DC power cable (or AC power).
 Press and hold the CFG button.
 Connect the DC power cable (or AC power). All LEDs blink 3 times, indicating all settings are now changed
back to factory-defaults.
 Release the CFG button.