User guide

Specifications
MultiView™ II DVI-TX Installation and User Guide 3
Chapter 3 Specifications
3.1 General Specifications
Item Description
Cable Required Category 5, 5e, 6 cable. Shielded or unshielded twisted pair. Low-skew.
Compliance CE, FCC Class A, IC Class / Class A, UL listed I.T.E Device, RoHS.
Video Support DVI-D, and HDMI by using a connector adapter for unprotected content only (non-HDCP).
Resolution &
Refresh Rate
See DDC/EDID chart located in section 3.3.
Interface Signal
Details
V
ideo-input:
Standard DVI-D interface specifications apply. DDC/EDID is supported.
Standard auxiliary Signals (including -A and –S versions):
L+R summed audio input: 47K ohms input impedance. A source device with 600 ohms
maximum output impedance is recommended.(analog audio input mode).
Simplex RS-232 input: 4.75K ohms input impedance (RS-232 mode).
SPDIF input: 75 ohms input impedance (S/PDIF input mode).
Duplex (232) option module:
Audio: Not supported.
Duplex input: 4.75K ohms input impedance.
Duplex (SA) or (SAP) option modules:
Stereo L/R audio input: 10K ohms input impedance. A source device with 600 ohms
maximum output impedance is recommended.
RS-232 input: 4.75K ohms input impedance.
Local-output port
drive impedance
Standard DVI interface specifications apply (at local video-output port).
DDC/EDID is supported.
Audio
Characteristics
Standard (A) version: Left+Right summed audio.
(232) version: This option module does not support audio.
(SA) & (SAP) versions: Left/Right true stereo audio.
Serial
Characteristics
Standard (S) version: Simplex-serial, any speed up to 115.2K baud. Transparent to format
and protocol.
Duplex (232) version: Any speed up to 115,200 baud (depending on application).
Transparent to format and protocol. Refer to Appendix-B for more information.
Duplex (SA) version: Speed fixed at 9600 baud. Transparent to format and protocol.
Duplex (SAP) version: Speed is adjustable in 9 steps from 1200 to 115K BAUD; format is
fixed to 8 data no parity; transparent to protocol.
Connectors
Standard connectors:
(2) DVI-female: Video in/out.
(1) RJ-45: MultiView CAT5 link output.
(1) 4 position phoenix: Auxiliary signal input.
(1) Coaxial (5.5mm OD, 2.5mm ID, 11mm L) jack: DC power input.
For (232), (SA) or (SAP) versions:
(1) DB9-F: Serial I/O.
Temperature
Tolerance
Operating: 32 to 104°F (0 to 40°C)
Storage: -4 to +140°F (-20 to +60°C)
Humidity Tolerance Up to 80% noncondensing
Enclosure Steel, black powder-coat finish.
Power
Input voltage: +5 VDC @ 1.2 Amps max.
Consumption: 6 watts maximum
Size 1.2"H x 4.2"W x 4.3"D (3.1 x 10.4 x 10.9 cm)
Weight 1.0 lb. (0.45 kg)
MTBF 100,000 hours