User guide

Installation
MultiView™ II XRTx Installation and User Guide 15
4.4 Sync Settings
The XRTx is factory-configured for auto-detecting the proper sync-mode (RepliSync-I normal/stretched). This
mode is generally compatible with all existing MultiView™ and MultiView™ II receiver products that support
RepliSync (if they are also using their factory-default settings). However, some video sources may require a
custom sync-mode setting (most especially at 1080p and 1920x1200 video resolutions). For these cases, one of
the other available sync-modes can be selected.
Note that any connected MultiView™ or MultiView™ II receiver should generally be set to the same sync-mode
and may require other configuration adjustments (such as sync-polarity). Otherwise, you may not get a proper
video display output at that receiver, or none at all.
Perform the procedure below while the transmitter is in the normal operating state (CFG indicator is off):
1. Press and release the CFG button once to access configuration-mode (CFG indicator = on).
2. Press and release the SEL button once. You will now be able to change sync-mode settings.
3. LED indicators 1-3 should be illuminated (either DIM or ON); all others (indicators 4-8) should be off.
4. Press the CFG button repeatedly to step through the available sync-mode settings as shown below.
5. To leave configuration-mode step through all the options OR leave the buttons untouched for 10 seconds.
Table 11: Sync-Mode Settings
LED1 LED2 LED3 Front Panel View Sync-Mode Setting
dim dim dim
The XRTx will auto-detect the required RepliSync-I
mode (“normal” or “stretched”). This is the factory-
default setting.
dim dim ON
Force RepliSync-I normal Horizontal sync-pulse
encoding.
dim ON dim
Force RepliSync-I “stretched” Horizontal sync-pulse
encoding.
dim ON ON Force RepliSync-II.
ON dim dim
Force fixed-sync mode. Note: A connected MultiView™
or MultiView™II receiver must also be in fixed-sync
mode and with H/V polarities selected at the receiver.
Note: RepliSync-II provides a greater degree of compatibility with high-definition formats such as 1080p and
1920x1200. Any connected receivers must also be set for RepliSync-II mode for this mode to be effective.
RepliSync-II mode is only available with MultiView™ II receivers.