User guide

Installation
MultiView™ II AK600DP/AK1200DP Installation and User Guide 14
4.5.4 Vsync Polarity Settings (LED7)
The receiver provides settings for Vsync polarity: (+) or (-).
The factory default setting is (+) Vsync polarity, or “ON” for configuration LED 7.
Perform the following procedure while the receiver is in the normal operating state (CFG indicator is off):
1. Press and hold the CFG button until the CFG indictor is ON. Release the CFG button.
a. LEDs 1-8 will show the current value for all Mode-1 configuration settings as bright/off.
2. Press and release the SKEW/SEL button three times.
3. LED indicator 7 should be illuminated (either DIM or ON); all others (indicators 1-6 and 8) should be off.
4. Press the UP and DOWN buttons to change Vsync polarity from Positive (bright) to Negative (dim).
5. To leave configuration-mode, leave the buttons untouched for 10 seconds or press the CFG button.
Note: This setting only has an effect if the sync-mode is set to “Fixed”.
4.5.5 Hsync Polarity Settings (LED8)
The receiver provides settings for Hsync polarity: (+) or (-).
The factory default setting is (+) Hsync polarity, or “ON” for configuration LED 8.
Perform the following procedure while the receiver is in the normal operating state (CFG indicator is off):
1. Press and hold the CFG button until the CFG indictor is ON. Release the CFG button.
a. LEDs 1-8 will show the current value for all Mode-1 configuration settings as bright/off.
2. Press and release the SKEW/SEL button four times.
3. LED indicator 8 should be illuminated (either DIM or ON); all others (indicators 1-7) should be off.
4. Press the UP and DOWN buttons to change Hsync polarity from Positive (bright) to Negative (dim).
5. To leave configuration-mode, leave the buttons untouched for 10 seconds or press the CFG button.
Note: This setting only has an effect if the sync-mode is set to “Fixed”.