User guide

Skew Module Installation
MultiView™ II AK600DP/AK1200DP Installation and User Guide 26
Appendix B Skew Module Installation
The AK600(1200)DP receivers have an optional skew compensation module that can be installed or removed.
To install the Skew Module:
1. Disconnect external DC power and remove the top cover.
2. In the center area of the PCB there should be 3 jumpers
installed on J16, pins 1-2, 4-5 and 7-8.
3. Remove these jumpers (save for future use).
4. Carefully orient the skew module with the Magenta logo
positioned as shown, and then firmly plug in the module so
that it mates completely with J16 and J17 on the main-
board. Incorrect orientation can cause damage to the
circuitry.
5. Double-check that all the J16 and J17 pins on the
mainboard are properly connected to the mating pins on
the skew module. It is easy to have a bent pin that causes
a shorted signal and possible circuitry damage.
6. Reassemble cover.
7. Connect power.
To remove the Skew Module, the procedure is opposite as
described. It is important to replace the 3 jumpers on J16 as
shown, or you will not have a video signal.
Figure 17: Jumpers
across J16 installed
Figure 18: Jumpers
across J16 removed
Figure 16: AK-600DP
receiver, cover removed.
Figure 19: AK-600DP
receiver, skew module
installed
J16
J17
Logo