users manual

Descriptions of encoder indicators are as follows.
Descriptions of stream status are as follows.
Check Record and Streaming Status
In the REMOTE interface, users can check recording status including recording time, available USB storage (shown as available time for recording); streaming status
including streaming time, streaming server address, streaming speeds, etc. Users can start/stop streaming or recording videos to the USB flash drive in this interface.
HDMI/SDI IN: Light being on indicates input signal is detected;
pulsing slowly indicates input signal is not detected.
■
Ethernet: Light being on indicates Ethernet is connected; pulsing slowly
indicates Ethernet is disconnected.
■
Wi-Fi: Light being on indicates network is detected; pulsing slowly
indicates network is not detected.
■
USB: Light being on indicates USB is available; pulsing slowly indicates
there is insufficient storage on the USB.
■
Resolving DNS: Indicates that domain name resolution is being performed
on the live streaming address.
■
Connecting: Indicates that the encoder is connecting to the live streaming
server
■
Waiting: Indicates the previous connection to the streaming server failed,
and the encoder is trying to reconnect.
■
Authenticating: Indicates the encoder has connected to the live streaming
server and live authentication is in progress.
■
Authentication Failed: If you connect the encoder to an RTMP server, make
sure your authentication settings are correct; if you connect the encoder to
■
45