User's Manual

www.HomelandHousewares.com
Magic Bullet Blender
Magic Bullet Blender
www.HomelandHousewares.com
Magic Bullet Blender
Magic Bullet Blender
32 33
When it’s time to whip up big batches of foods like pancakes, milk-
shakes, or frozen drinks, the Magic Bullet Blender has all the power
and capacity of those expensive, bulky blenders without taking up all
that counter space. The Blender Lid has two pouring spouts, one for
straining and one for pouring, and a pop-out top, so you can add ingredi-
ents as you blend. Plus, everything is dishwasher-safe (top rack only), so
cleanup is fast and easy.
Assembling the Magic Bullet Blender
Just … Twist the Cross Blade onto the bottom of
the Blender Pitcher.
Then … Place the Blender on the Magic Bullet
Power Base.
Using the Magic Bullet Blender
The Magic Bullet Blender is just like regular
blenders, without all the confusing buttons.
Simply … Place the assembled Blender onto the
Power Base.
Then … Push down on the Blender and twist clockwise until the tabs
lock under the lip of the Power Base (Lock On mode).
And … Put on the Blender Lid and blend.
Never run the Magic Bullet for more than one minute at
a time, as it can cause permanent damage to the motor. If the
motor stops working, unplug the Power Base and let it cool for
a few hours before attempting to use it again. Your Magic Bullet
has an internal thermal breaker that shuts the unit off when it overheats.
Letting the thermal breaker cool down should allow it to reset.
If the blade stops in Lock On mode, unplug the Magic
Bullet immediately. Sometimes, especially when the mo-
tor is coming up to speed, a hard ingredient, such as a carrot
chunk, can get stuck in the blade. If the blade stops, UNPLUG
THE MAGIC BULLET IMMEDIATELY and clear the blade before proceeding.
Running the machine when the blades are obstructed can ruin the motor.
Never run the Magic Bullet for more than one minute; it can
cause permanent damage to the motor. If you still want more
juice after 60 seconds of juicing, simply stop for a few seconds,
then continue for another minute. If you do overheat the motor and it
stops, unplug the Power Base and let it rest for a few hours before
attempting to use it again.